Owner's manual

Skip, Gauge, and Probing Cycles
Chapter 27
27-26
Thisfeature:
Used with G26 adaptive depth:
Dualand De-skewaxes Isincompatible with the adaptive depthprobe. An erroris
generated when youattemptto run an adaptivedepth
cycle ifone ofth ese types ofaxes areconfigured asthe
adaptive depth axis.
Mid Start/ProgramRestart If motion to the block that is selected for Mid Start/Program
Restartgeneratesa move thatfires the depthprobe,a
unexpected depth probe tripwilloccur. You can notuse
these features to startatanyblockthatwould normally
havebeen executed withthedepthprobetripped.
PolarProgramming(G16) Youcan notprograma G26 blockifthe adaptive depth axis
isin the currentplaneand the control isinpolar
programming mode.
If you would like to monitor your adaptive depth probe position, you can
view the probe location on the adaptive depth probe axis monitor screen.
The system i nstaller can also make this information available through a
PAL display page by monitoring adaptive depth axis information. Refer to
your Integration and Maintenance Manual for details on using the monitor
pages. Your system installer may have password protected the monitor
softkey.
END OF CHAPTER