Owner's manual

Milling Fixed Cycles
Chapter 26
26-20
The format for the G82 cycle is as follows:
G82X__Y__Z__R__P__F__L__;
Where : Is :
X,Y
specifieslocation ofthe hole.
Z
defines the holebottom.
R
defines the Rpointlevel.
P
defines the dwell period atholebottom.
F
defines the cutting feedrate.
L
defines the numberoftimesthe millingfixedcycle isrepeated.
(See section 26.3 for a detailed explanation of these parameters.)
Important: The programmer or operator must start spindle rotation.
Figure 26.9
G82: Drilling Cycle, Dwell/Rapid Out
initial point
level
Cutting feed
Rapid feed
R
Z
Dwell at hole bottom
Hole bottom
R point level
1
2
3
4
5
(G82): Drill Cycle,
Dwell/Rapid Out