Owner's manual

Milling Fixed Cycles
Chapter 26
26-18
The format for the G80 cancel or end fixed cycles is as follows:
G80;
Programming a G80 cancels the currently active milling fixed cycle mode.
(G00, G01, G02, or G03 will also cancel any active milling fixed cycle.)
If milling fixed cycles are canceled with a G80, program execution returns
to the mode which was in effect when the cycles were last turned on, for
example, G00 - G03.
The format for the G81 cycle is as follows:
G81X__Y__Z__R__F__L__;
Where : Is :
X,Y
specifieslocation ofthe hole.
Z
defines the holebottom.
R
defines the Rpointlevel.
F
defines the cutting feedrate.
L
defines the numberoftimesthe millingfixedcycle isrepeated.
(See section 26.3 for a detailed description of these parameters.)
Important: The programmer or operator must start spindle rotation.
(G80): Cancel or End Fixed
Cycles
(G81): Drilling Cycle, No
Dwell/Rapid Out