Owner's manual

9/Series PAL Reference Manual

Index (General)

9/Series Mill

Table of Contents

Operation and Programming Manual

3.1.2SettingToolOffsetTables 3-5..................................................

3.1.3SettingOffsetData Using{MEASURE} 3-9........................................

3.1.4ToolOffsetRange Verification 3-10...............................................

3.2 Changing the ActiveTool Offset{ACTIVE OFFSET} 3-12..................................

3.3 Work Coordinate SystemOffsetTables{WORK CO-ORD} 3-14..............................

3.3.1SettingWork Coordinate SystemTables 3-15.......................................

3.4 Backing Up OffsetTables 3-17.....................................................

3.5 Programmable ZoneTable 3-21....................................................

3.6 Single DigitFeedrateTable 3-23....................................................

Chapter 4

Manual/MDI Operation Modes

4.0 Chapter Overview 4-1..........................................................

4.1 ManualOperating Mode 4-1......................................................

4.1.1Jogging anAxis 4-2........................................................

4.1.2Continuous Jog 4-3.........................................................

4.1.3IncrementalJog 4-3........................................................

4.1.4HPGJog 4-4.............................................................

4.1.5ArbitraryAngleJog 4-5......................................................

4.1.6Jog Offset 4-6.............................................................

4.1.7Resetting Overtravels 4-6.....................................................

4.2 MechanicalHandle Feed(ServoOff) 4-8.............................................

4.3 Removingan Axis(Axis Detach) 4-8................................................

4.4 Manual MachineHoming 4-8.....................................................

4.5 MDIMode 4-11................................................................

4.5.1MDIBasicOperation 4-12.....................................................

Chapter 5

Editing Programs Online

5.0 Chapter Overview 5-1..........................................................

5.1 Selecting the ProgramToEdit 5-2..................................................

5.2 Editing Programs at the Control (Online) 5-3..........................................

5.2.1 M oving the Cursor {STRINGSEARCH} and Cursor Size {CHAR/WORD} 5-5................

5.2.2EnteringCharacters andBlocks 5-7.............................................

5.2.3 Changingand Inserting {MODIFYINSERT} 5-7.....................................

5.2.4Erasing Charactersand Blocks 5-11.............................................

5.2.5Sequence Numbers {RENUMPRGRAM} 5-13.......................................

5.2.6Merging PartPrograms {MERGEPRGRAM} 5-15....................................

5.2.7ExitingEditMode {EXIT EDITOR} 5-16............................................

5.3 Programming Aids {QUICK VIEW} 5-17............................................

5.3.1Selectinga QuickViewPlane 5-19...............................................

5.3.2Using{QPATH+PROMPT}SamplePatterns 5-20....................................

5.3.3 G -- code FormatPrompting{GCODEPROMPT} 5-24..................................

5.3.4 Mill Cycle Format Prompting 5-26...............................................