Owner's manual

Tool Control Functions
Chapter 20
20-23
At this point if it is desired to delete any or all tool groups that already
exist for some reason follow these steps:
To delete a select tool group press the {DELETE GROUP} softkey.
Key in the desired group number to delete and press the [TRANSMIT]
key. This will delete all information in the tool group including the tool
offset numbers, threshold rate, tool numbers, e tc....
To delete all of the tool groups press the {DELETE ALL} softkey. The
control will prompt “DELETE ALL TOOL MANAGEMENT DATA?
(Y/N):”. Entering “Y”will delete all tool management data that has
been entered into the management tables (this will not delete any G10
programs t hat are backups or used to set the tool management tables).
Entering “N”will abort the delete operation.
4. Key in the group number to edit and press the {EDIT GROUP} key.
The following screen showing all the information for that tool group
will be displayed.
Figure 20.7
Typical Tool Group Data Screen
ENTER VALUE=
EDIT TOOL GROUP PAGE 1 OF 1
(ACTIVE PROGRAM NAME) THRESHOLD RATE=80%
ENTRY TOOL NUMBER LIFE TYPE = TIME
11
22
34
40
50
CHANGE
TOOL
INSERT
TOOL
DELETE
ALL
CHANGE
TYPE
CHANGE
T RATE