Owner's manual

9/Series PAL Reference Manual

Index (General)

9/Series Mill

Table of Contents

Operation and Programming Manual

Chapter 1

Using This Manual

1.0 Chapter Overview 1-1..........................................................

1.1 Audience 1-1................................................................

1.2 Manual Design 1-1............................................................

1.3 Reading thisManual 1-3........................................................

1.4 Termsand Conventions 1-4......................................................

1.5 Warnings,Cautions,and ImportantInformation 1-5......................................

1.6 RelatedPublications 1-5........................................................

Chapter 2

Basic Control Operation

2.0 Chapter Overview 2-1..........................................................

2.1 OperatorPanelOperations 2-1....................................................

2.1.1Keyboard 2-3.............................................................

2.1.2CalculatorFunction 2-4......................................................

2.1.3Softkeys 2-8..............................................................

2.1.4CRT 2-10................................................................

2.1.5Portable Operator Panel 2-11...................................................

2.2 TheMTBPanel 2-12............................................................

2.3 Software MTB Panel{FRONTPANEL} 2-15............................................

2.4 Power Procedures 2-21..........................................................

2.4.1Turning Power On 2-21.......................................................

2.4.2 Turning Power OFF 2-22.....................................................

2.5 ControlConditions atPower-Up 2-23................................................

2.6 Emergency Stop Operations 2-24...................................................

2.6.1EmergencyStop Reset 2-24...................................................

2.7 AccessControl 2-25............................................................

2.7.1Assigning Access Levels and Passwords 2-26......................................

2.7.2PasswordProtectable Functions 2-29............................................

2.7.3Entering Passwords 2-31.....................................................

2.8 Changing Operating Modes 2-33...................................................

2.9 Displaying Systemand Machine Messages 2-37........................................

2.9.1Clearing Active Messages {CLEARACTIVE} 2-40....................................

2.10 The InputCursor 2-41..........................................................

2.11 {REFORMM EMOR Y} 2-41.......................................................

2.12 Removingan Axis (AxisDetach) 2-43...............................................

2.13 Time Parts CountDisplay Feature 2-43..............................................

Chapter 3

Offset Tables and Setup

3.0 Chapter Overview 3-1..........................................................

3.1 ToolOffs etTable {TOOL GEOMET} and{TOOLWEAR} 3-1...............................

3.1.1ToolOffsetDimensionalParameters 3-2..........................................