Owner's manual

Tool Control Functions
Chapter 20
20-13
Figure 20.5
Typical Random Tool Pocket Assignment Screen
POCKET ASSIGNMENT TABLE PAGE 1 OF 2
PKT TOOL PKT TOOL PKT TOOL
001 0002 002 003 0001
004 005 0003 006 XXXX
007 0007 008 XXXX 009
010 011 012
013 014 015
016 017 018 XXXX
019 0006 020 XXXX 021
022 023 024
025 026 027
028 029 030
031 032 033
034 035 036
037 038 039
REPLCE
VALUE
CLEAR
VALUE
CUSTOM ACTIVE BACKUP
The columns labeled PKT give the pocket numbers of the tool changer.
The columns labeled TOOL give the tool number of the tool in the
corresponding pocket. Pockets with no tools assigned to them show no
information next to the pocket number. Pockets with tools shown as
XXXX indicate t hat a custom tool (tool that requires more then one
pocket) has been assigned to use that pocket.
3. Move the cursor to the pocket number for which an assignment or
change is to be made. This is done by pressing the up, down, right, or
left cursor keys on the operator panel. Move the cursor full pages by
holding down the [SHIFT] key while pressing the up or down cursor
keys. The selected pocket is shown in reverse video.
Important: If random tool is not to be used for a specific system, make
sure that none of the t ool pockets have tool numbers assigned to them.