Owner's manual

Coordinate System Offsets
Chapter 11
11-14
Once the work c oordinate system is offset, a ll absolute positioning
commands in the program are executed as coordinate values in the offset
coordinate system.
Example 11.5
Work Coordinate System Offset (G92)
Program Block Comment
X25.Y35.; rapid move to X25, Y35 in the G54 work coordinate
system.
G92X10.Y10.; Redefines current axis position to have the
coordinates X10, Y10
Note that the zero point of the offset G54 work coordinate system will be
10 units away from the current tool location in both the X and Y directions.
If the Y value had not been entered in the G92 block, the Y coordinate
location would have remained unchanged (Y35.)
Figure 11.10
Results of Example 11.5
Machine coordinate system zero point
Zero point for the G54
work coordinate system
New zero point established
by the G92 block
10
20 30
10
30
20
Tool position
X
X
Y
Y