Owner's manual

Introduction to Programming
Chapter 10
10-29
G-Code TypeFunctionModal Group
G86 BoringCycle(Spindle Stop,RapidOut)
G87 Back Boring Cycle
G88 BoringCycle(Spindle Stop,ManualOut)
G88.1 00 PocketMillingRoughing Cycle Non--Modal
G88.2 PocketMilling Finishing Cycle
G88.3 PocketMillingRoughing Cycle
G88.4 PocketMilling Finishing Cycle
G88.5 Hemispherical Milling (RoughingCycle)
G88.6 Hemispherical Milling (FinishingCycle)
G89 09 BoringCycle(WithDwell,FeedOut) Modal
G89.1 00 IrregularPocketMilling(Roughing Cycle)
1
Non--Modal
G89.2 IrregularPocketMilling(Finishing Cycle)
1
G90 03 Absolute Mode Modal
G91 IncrementalMode
G92 00 Coordinate SystemOffset(Using ToolPositions) Non-Modal
G92.1 CoordinateSystemOffset(Cancel)
G92.2 Selected Coordinate SystemOffsets (Cancel)
G93 05 Inverse TimeFeed Mode Modal
G94 F eed-per-minute mode
G95 F eed-per-revolution Mode
G98 10 Initial Level Returnin MillingCycles Modal
G99 R-Point Level Returnin Milling Cycles
1
Important:The IrregularPo cket Milling Cyclesfeature(G89.1 and G89.2)isonly available p riortosystem
software release 12.xx. Any attempttoprograma G89.1 orG89.2 inrelease12.xx orlaterwillresultin the error
message,“IllegalG--code”.
A set of default G--codes become effective at power up, when the control is
reset, or an emergency stop condition is reset. T hese default G--codes are
selected by the system installer in AMP. These default G--codes can be
seen on the status display screen after power up or control reset.