Owner's manual

Introduction to Programming
Chapter 10
10-28
G-Code TypeFunctionModal Group
G48 00 ResetAcc/DectoDefault AMPedValues Non--Modal
G48.1
0
0
Acceleration Ramp forLinearAcc/Dec Mode
N
o
n
-
-
M
o
d
a
l
G48.2 DecelerationRamp for Linear Acc/Dec Mode
G48.3 AccelerationRamp forS--Curve Acc/Dec Mode
G48.4 Deceleration RampforS--Curve Acc/Dec Mode
G48.5 Programmable JerkValue
G49 08 Tool LengthOffsetCancel) Modal
G50.1 11 Programmable MirrorImage (Cancel) Modal
G51.1 Programmable MirrorImage
G52 00 OffsettingCoordinateZero Point Non-Modal
G53 Motion inMachineCoordinateSystem
G54 12 PresetWorkCoordinateSystem1 Modal
G55 PresetWorkCoordinateSystem2
M
o
d
a
l
G56 PresetWorkCoordinateSystem3
G57 PresetWorkCoordinateSystem4
G58 PresetWorkCoordinateSystem5
G59 PresetWorkCoordinateSystem6
G59.1 PresetWork Coordinate System7
G59.2 PresetWork Coordinate System8
G59.3 PresetWork Coordinate System9
G61 13 ExactStop Mode Modal
G62 AutomaticCorner Override
G63 Tapping Mode
G64 Cutting Mode
G65 00 Paramacro Call Non-Modal
G66 14 ParamacroModalCall Modal
G66.1 Paramacro ModalCall
G67 Paramacro ModalCall(Cancel)
G68 16 Part Rotation Modal
G69 PartRotation (Cancel)
G73 09 Deep Hole PeckDrilling Cycle (With dwell) Modal
G74 Left-HandTappingCycle
G74.1 Left-Hand Solid Tapping Cycle
G76 BoringCycle(Spindle Shift)
G80 Cancel orEnd FixedCycle
G81 09 Drilling Cycle (No Dwell,Ra pid Out) Modal
G82 Drilling Cycle (Dwell,Rapid Out)
G83 Deep Hole PeckDrilling Cycle
G84 Right-Hand TappingCycle
G84.1 Right-HandSolidTapping Cycle
G85 Bo ring Cycle (No Dwell,Feed Out)