Owner's manual

Introduction to Programming
Chapter 10
10-26
Table 10.E
G-codes
G-Code ModalGroup Function Type
G00 01 Rapid Positioning Modal
G01 Linear Interpolation
G02 Circular/HelicalInterpolation (Clockwise)
G03 Circular/HelicalInterpolation (Counterclockwise)
G04 00 Dwell Non-Modal
G05 Send Commandand Waitfor ReturnStatus(for9/SeriesData
HighwayCommunication Module)
N
o
n
-
M
o
d
a
l
G05.1-G05.4 SendCommand withoutWaitingforReturnStatus
(for9/SeriesDataHighwayCommunication Module)
G09 Exact Stop
G10L2 Setup WorkCoordinate OffsetTables
G10L3 Setup Tool ManagementTable
G10L10 Setup ToolLengthValuesGeometryTable
G10L11 Setup ToolLengthValuesWearTable
G10L12 Setup ToolRadiusValuesGeometryTable
G10L13 Setup ToolRadiusWearValuesWearTable
G10.1 Setup RandomToolTable
G10.2L1 Communication Configuration Information (for9/Series Data
HighwayCommunication Module)
G10.2L2 OutputCommandTable(for9/Series DataHighway
Communication Module)
G10.2L3 DownloadConfiguration Information (for9/SeriesData
HighwayCommunication Module)
G11 Setup Tool ManagementTable(Cancel)
G12.1 21 PrimarySpindle Controlling Modal
G12.2 Auxiliary Spindle 2 Controlling
G12.3 Auxiliary Spindle 3 Controlling
G13 QuickPath Plus (Use First Intersect.)
G13.1 QuickPathPlus(UseSecondIntersect.)
G14 19 Scaling(Disable) Modal
G14.1 Scaling (Enable)
G15 15 PolarCoordinateProgramming (Cancel) Modal
G16 PolarCoordinate Programming
G16.1 CylindricalInterpolation
G17 02 Plane Selection Modal
G18 Plane Selection
G19 Plane Selection
G20 06 Inch System Selection Modal
G21 MetricSystemSelection