Owner's manual

Introduction to Programming
Chapter 10
10-20
Table 10.B
Word Formats and Descriptions
Address Valid Range Inch Valid Range Metric Function
A 8.6 8.5 Rotary axis aboutX(AMPassigned)
3.3 3.3 Angle inQuickPath Plus programming
B 8.6 8.5 Rotary axis aboutY(AMPassigned)
3.0 3.0 Second miscellaneousfunction(AMP assigned)
C 8.6 8.5 Rotary axisaboutZ (AMPassigned)
8.6 8.5 Chamferlength in QuickPathPlusprogramming
D 3.0 3.0 Toolradiuscompensationnumber
8.6 8.5 Fixed cycleparameter.
E 2.6 3.7 Thread lead
F 8.6 8.5 Feedratefunction (F--word)
G 2.1 2.1 Preparatoryfunction(G--code)
H 6.0 6.0 Toollength offsetnumber
8.6 8.5 Parameterforprobing cycles.
I 8.6 8.5 Xarc centerin circularinterpolation
8.6 8.5 Xleadin helical interpolation
8.6 8.5 Paramete r infixed cycles(AMP assigned)
8.6 8.5 Exitmovevector in cuttercompensation
J 8.6 8.5 Yarccenter in circularinterpolation
8.6 8.5 Yleadin helical interpolation
8.6 8.5 Paramete r infixed cycles(AMP assigned)
8.6 8.5 Exitmovevector in cuttercompensation
K 8.6 8.5 Z arccenter in circularinterpolation
8.6 8.5 Paramete r infixed cycles(AMP assigned)
8.6 8.5 Exitmovevector in cuttercompensation
L 3.0 3.0 Numberofrepetitions
M 3.0* 3.0* Miscellaneous function
N 5.0 5.0 Sequence number
O 5.0 5.0 Programname
P 5.0 5.0 Subprogramname
5.3 5.3 Length ofdwellin G04and fixed cycles
Q 8.6 8.5 Parameterin fixed cycles
R 8.6 8.5 Arcradius
8.6 8.5 Return pointin fixedcycles
8.6 8.5 QuickPathPlusradiusdesignation
* Some of thesystem basic M --codes are3.1 format however allsystem installer definedM--codes must remain 3.0. See Table 10.F on page for details.