Owner's manual

Chapter
2
2
-
1
Basic Control Operation
This chapter describes how to operate the Allen-Bradley 9/Series control,
including:
Topic: On page:
MTBpanel 2-12
{FRONT PANEL} 2-15
Power-up 2-23
Emergencystops 2-24
Access contro l 2-25
Changingmodes 2-33
Displaysystemand messages 2-37
Input cursor 2-41
{REFORM MEMORY} 2-41
Removing anaxis 2-43
Time partcount 2-43
We also tell you about the control conditions automatically assumed at
power up.
Use the operator panel to perform these operations:
display a part program
display c ontrol status and tool position
edit a part program
display a nd enter tool offset data
display the status of input/output signals
display a nd enter programmable zone boundaries
set the level of protection of part programs, tool offset data, AMP data,
etc.
Use the operator panel to perform many other operations. We describe
these operations in the remaining chapters of this manual.
2.0
Chapter Overview
2.1
Operator Panel Operations