Owner's manual

Displays and Graphics
Chapter 8
8-30
4. Set Auto Size. Use the up and down cursor keys to select the
parameter. Set auto size by pressing the left or right cursor keys. The
value for the selected parameter changes each time you press the left
or right cursor key.
If you turn this parameter “ON”, the control re-sizes the graphics
screen to the size of the programmed part. To use this feature, turn
this parameter “ON”, then run the part program. When the part
program is finished, the control re-sizes the graphics screen then turns
this parameter “OFF.”
5. Set Grid Lines. Use the up and down cursor keys to select the
parameter. Set it by pressing the left or right cursor keys. The data
for the selected parameter changes each time you press the left or
right cursor key.
When th is
parameteris:
The control:
On overlaysthe graphics screen withgridlines. Thesegridlinesare
solidlinesdrawnatthe axiscoordinate tickmarks.
Off doesnotdisplaylines.
6. Set Overtravel Z one Lines. Use t he up and down cursors to select
the parameter. Set it by pressing the left or right cursor keys. The
data for the selected parameter changes each time you press the left or
right cursor key.
When th is
parameteris:
The control:
On drawsovertravel/zonelineson the graphics screen. These
overtravel/zonelinescorrespond to the activesoftwareovertravel
limitsand the programmablezone limits. Thesoftwareovertravel
limits arespecified inAMPby yoursysteminstaller. The
programmable zonelimitsmustbeprogrammed bytheoperator. T he
software overtravel andprogrammable zonelinesare dotted lines.
Off doesnotdisplaylines.