Owner's manual

Running a Program
Chapter 7
Running a Program
Chapter 7
7-24
In automatic mode, the control manages machine operations according to
the commands in a part program.
CYCLE START ---- begins part program execution
CYCLE STOP ---- stops part program execution
WARNING: Always test a program prior to automatic
operation. Always verify that the workspace is clear and a ll
safety features are intact before pressing CYCLE START.
Figure 7.5
Automatic Mode
CUTTING TOOL
CYCLE
START
WORK PIECE
0 12345 .
S____ M____ .
G92 X ____Y____ .
D_______ .
G00 ______ .
G01 F ______ .
A
.
A
9/Series
Execution of a part program continues until the control encounters an M02
or M30. If the control does not encounter an M02 or M30 at the end of a
program, the error message “MISSING M02/M30”appears.
Execution can be stopped at any time by using any of the methods
described in section 7.7 or by pressing the <EMERGENCY STOP> button.