Owner's manual

9/Series PAL Reference Manual
Index (General)
9/Series Mill
Table of Contents
Operation and Programming Manual
xi
Chapter 28
Paramacros
28.0 Chapter Overview 28-1.........................................................
28.1 Paramacros 28-1.............................................................
28.2 Parametric Expressions 28-2.....................................................
28.2.1 Basic Mathematic al Operators 28-2............................................
28.2.2 MathematicalFunctionCommands 28-4........................................
28.2.3 Parametric Expressionsas G-- or M--Codes 28-6..................................
28.3 TransferofControlCommands 28-7................................................
28.3.1 ConditionalOperators 28-7..................................................
28.3.2 GOTOandIF-GOTO Commands 28-8.........................................
28.3.3 DO-ENDand WHILE-DO-ENDCommands 28-10...................................
28.4 ParameterAssignments 28-12...................................................
28.4.1LocalParameterAssignments 28-12............................................
28.4.2 CommonParameters 28-15..................................................
28.4.3 SystemParameters 28-15...................................................
28.4.4 PALParameters 28-33......................................................
28.4.5Shared Dual-Process Parameters (#7100- 7199) 28-35..............................
28.5 AssigningParameterValues 28-36.................................................
28.6 Macro CallCommands 28-44.....................................................
28.6.1Non-Modal Paramacro Call(G65) 28-45..........................................
28.6.2ModalParamacro Call(G66) 28-46.............................................
28.6.3ModalParamacro Call(G66.1) 28-48............................................
28.6.4AMP-defined G-Code MacroCall 28-50..........................................
28.6.5AMP-Defined M-CodeMacro Call 28-51..........................................
28.6.6AMP-Defined T-- , S--,and B--Code Macro Call 28-51.................................
28.6.7Nesting Macros 28-52.......................................................
28.7 Macro OutputCommands 28-54...................................................
Chapter 29
Program Interrupt
29.0 Chapter Overview 29-1.........................................................
29.1 Enablingand Disabling Interrupts(M96/M97) 29-1......................................
29.2 Interrupt RequestConsiderations 29-4..............................................
29.3 InterruptTypes 29-5...........................................................
29.4 TheInterruptProgram 29-8......................................................
Chapter 30
Using a 9/Series Dual-processing System
30.0 Chapter Overview 30-1.........................................................
30.1 Defining ofa Dual-processingSystem 30-1...........................................
30.2 Operating aDual-processingSystem 30-2............................................
30.3 SynchronizingMultiplePartPrograms 30-7...........................................
30.4 SpindleControlforDual-- processingSystems 30-12.....................................