Owner's manual

Editing Programs Online
Chapter 5
5-31
Figure 5.7
Linear Digitize Screen
X 0.000
Y 0.000
Z 0.000
F 0.000 MMPM S 00
DIGITIZE:
METRIC, ABS, G17
ABSOLUTE [ MM ] GOO
STORE
END PT
EDIT &
STORE
Reposition the tool at the desired end point of the linear move using any of
the following methods.
Jog the Axes in manual mode.
Automatically move the axes by executing a part program or MDI
program.
Manually move the axes using any means as long as the encoder is still
actively recording the tool position (see documentation prepared by the
system installer).