Owner's manual

9/Series PAL Reference Manual
Index (General)
9/Series Mill
Table of Contents
Operation and Programming Manual
viii
18.4.7ShortBlock Acc/Dec G36,G36.1 18-22.........................................
Chapter 19
Dual---axis Operation
19.0 Chapter Overview 19-1.........................................................
19.1 Dual--axisOperation 19-1.......................................................
19.1.1 Parking aDualAxis 19-3...................................................
19.1.2 Hominga DualAx is 19-4...................................................
19.1.3 Programming a Dual Axis 19-5...............................................
19.1.4 OffsetManagementfora DualAxis 19-7.......................................
Chapter 20
Tool Control Functions
20.0 Chapter Overview 20-1.........................................................
20.1 Programming a T--word 20-1.....................................................
20.2 ToolLengthOffsetFunction(G43,G44,G49) 20-3......................................
20.2.1 ActivatingToolLength Offsets 20-8............................................
20.2.2ToolLength Offset (TLO)AxisSelection(G43.1,G44.1) 20-9...........................
20.3 RandomTool 20-11............................................................
20.4 Programming Alterations of the Offset Tables (G10L10 -- G10L13) 20-18.......................
20.5 AutomaticToolLife Management 20-19..............................................
20.5.1ToolDirectory Data 20-20....................................................
20.5.2Assigning DetailedToolData 20-25.............................................
20.5.3 Programming Data and Backing Up Tool Management Tables (G10L3,G11) 20-29............
20.5.4 Programming Using Tool Management 20-33......................................
Chapter 21
Cutter Diameter Compensation (G40, G41, G42)
21.0 Chapter Overview 21-1.........................................................
21.1 ActiveCutterCompensation 21-3..................................................
21.2 Cutter Compensation Generated Blocks G39, G39.1 21-7................................
21.3 CutterCompensation (Type A) 21-10................................................
21.3.1 CutterCompensation Type AEntry Moves 21-10...................................
21.3.2 CutterCompensation Type AExitMoves 21-14....................................
21.4 CutterCompensation (Type B) 21-20...............................................
21.4.1 CutterCompensation Type BEntry Moves 21-20...................................
21.4.2 CutterCompensation Type BExitMoves 21-24...................................
21.5 ToolPathDuring Cutter Compensation 21-30..........................................
21.6 Cutter Compensation SpecialCases 21-35............................................
21.6.1 Changing Cutter CompensationDirection 21-35....................................
21.6.2 Too Many Non-Motion Blocks 21-39............................................
21.6.3 CornerMovementAfter GeneratedBlocks 21-41...................................
21.6.4 Changing Cutter Radius DuringCompensation 21-43................................
21.6.5 MDIor ManualMotionDuring Cutter Compensation 21-46.............................