Owner's manual

9/Series PAL Reference Manual
Index (General)
9/Series Mill
Table of Contents
Operation and Programming Manual
vii
Chapter 15
UsingQuickPathPlust
15.0 Chapter Overview 15-1.........................................................
15.1 Using QuickPathPlus 15-1......................................................
15.2 Linear QuickPath Plus 15-3......................................................
15.3 Circular QuickPath Plus (G13,G13.1) 15-7...........................................
Chapter 16
Using Chamfers and Corner Radius
16.0 Chapter Overview 16-1.........................................................
16.1 Chamfers and Corner Radius 16-1.................................................
Chapter 17
Spindles
17.0 Chapter Overview 17-1.........................................................
17.1 Controlling Spindle (G12.1,G12.2, G12.3) 17-1........................................
17.2 SpindleOrientation(M19) 17-3...................................................
17.3 SpindleDirection (M03,M04,M05) 17-5.............................................
17.4 Synchronized Spindles 17-6.....................................................
17.4.1UsingtheSpindle SynchronizationFeature 17-7...................................
17.5 SpecialConsiderations for SpindleSynchronization 17-9.................................
Chapter 18
Programming Feedrates
18.0 Chapter Overview 18-1.........................................................
18.1 Feedrates 18-1...............................................................
18.1.1 Feedrates AppliedDuring Cutter Compensation 18-2................................
18.1.2 Inverse Time FeedMode(G93) 18-4..........................................
18.1.3 Feed--Per--Minute Mode (G94) 18-5...........................................
18.1.4 Feed--Per--RevolutionMode(G95) 18-5.........................................
18.1.5 Rapid Feedrate 18-6......................................................
18.1.6 Feedrate Overrides 18-7...................................................
18.1.7 Feedrate Limits (Clamp) 18-8................................................
18.2 Feedrates to ControlTorque Adaptive Feed(G25) 18-9..................................
18.3 SpecialAMPAssigned Feedrates 18-12..............................................
18.3.1Single DigitF--words 18-12...................................................
18.3.2External FeedrateSwitch 18-13...............................................
18.4 AutomaticAcceleration/Deceleration (Acc/Dec) 18-14....................................
18.4.1ExponentialAcc/Dec 18-15...................................................
18.4.2LinearAcc/Dec 18-16.......................................................
18.4.3S --CurveAcc/Dec 18-17.....................................................
18.4.4Programmable Acc/Dec 18-18.................................................
18.4.5Precautions onCornerCutting 18-20............................................
18.4.6Spindle Acceleration(Ramp) 18-22..............................................