Owner manual

Chapter
17
17-1
Cylindrical Grinding Fixed Cycles
This chapter describes the cylindrical grinding cycles available with the
control. You can use these cycles to program axis motions to perform
common grinding operations. Topics include:
Topic: On page:
CylindricalGrinding Considerations 17-3
CylindricalGrinding Parameters 17-9
G81 and G81.1 Reciprocation withoutPlunge 17-11
G82 and G82.1 Incremental Face Grinding (axis1) 17-12
G83 and G83.1 Incremental Plunge Grinding (axis2) 17-16
G84 and G84.1 Multi-passF ace Grinding (axis 1) 17-20
G85 and G85.1 Multi-passDiameterG rinding (axis 2) 17-23
G86 and G86.1 ShoulderG rinding 17-26
G87 and G87.1 ShoulderG rinding with Face Plunge 17-28
G88 and G88.1 ShoulderG rinding with DiameterPlunge 17-30
G89 and G89.1 Multi-Step PlungeGrindingwith Blend

17-32
 Cycle not available on 9/240grindersystems
Figure 17.1 shows the motions of the eight cylindrical grinding cycles
descri bed in this chapter.
17.0
Chapter Overview