Owner manual

Chapter 2
Quick Start
Chapter Objectives
This chapter provides the necessary steps to get the DeviceNet
Pendant Station operating on the network. It contains the following
sections:
Data Rate Configuration
This device is Auto Baud enabled. There is no need to configure data
rate.
Node Address Configuration
Node address is set through node commissioning.
For more information on node address configuration, please see
Chapter 3 – Installation and Mounting (Setting the DeviceNet node
address).
Section Page
Data Rate Configuration 2-1
Node Address Configuration 2-1
Connection to the Network 2-2
Pendant Station Parameter Configuration 2-2
Scanner Configuration 2-4