Instruction Manual

Contact Cartridges
Contact Cartridges Reconfiguration (N.O. N.C.)
8 -12 lb-in
(.9 - 1.4 N-m)
min - 1 x #18 AWG (.75 mm
2
)
max - 2 x #12 AWG (4.0 mm
2
)
7 - 14 lb-in
(.8 - 1.6 N-m)
5/16"
(7.9 mm)
Use Copper Wire Only
14 - 18 lb-in
(1.6 - 2.0 N-m)
Remove front cover.
Remove drive bar.
Loosen screw(s).
Convert contacts
N.O. N.C.
Install contact
cartridge.
1
2
4
5
Tighten terminal
screw(s).
7
6
Install drive
bar
8
2
Install front cover
9
Remove contact
cartridge.
3
Any combination of N.O. & N.C.
red cartridges must be used.
Do not use in Timers or Latches.
Cat. No. Contact Ratings
Continuous
Contact Ratings
Make / Break
10 A
600V AC
10 A
20 A
Lt. Grey
Black
Lt. Grey
Standard
Overlap
Master
700-CP1
700-CP11Z
700-CPM
35 ALt. GreyTandem (2 Masters) 700-CPH
Red
Safety (Standard) 700-CPS 10 A
Red
Safety (Master) 700-CMS 20 A
600V AC
NEMA
A600
NEMA
A600
(2) X NEMA
A600
(2) X NEMA
A600
NEMA
A600
(2) X NEMA
A600
600V DC
NEMA
P600
NEMA
P600
(2) X NEMA
P600
(2) X NEMA
P600
NEMA
P600
(2) X NEMA
P600
White
Logic Reed 700-CPR 500ma
@ 150 VDC
25 W (Max)
500ma
@ 150 VDC
25 W (Max)
200ma
@ 30 VDC
6 W (Max)
5 A
600V DC
5 A
10 A
20 A
5 A
10 A
200ma
@ 30 VDC
6 W (Max)
ATTENTION: Do not install the logic reed cartridge in a relay, timer or latch unit that is located next to a
Bulletin 700 Type R, RM, RTC sealed contact relay or other device with a strong magnrtic leakage field.
As erratic contact action could result. Because the logic reeds require very little force to operate. At least
2 standard cartridges are required in the relay to provide maximum mechanical life.
35A Jumper Kit Installation
ATTENTION: Both cartridges must be of the same configuration (N.O. or N.C.) (4 N.C. or 6 N.O.
Jumper Kits Maximum per AC or DC Relay) . If a kit is added to the third deck of an AC Relay, be
sure the enclosure is a 700-N31 Series B which has an electrical tape added inside the cover.
Because of a high inner barrier, Jumper Kits should be used on Series B 700-PT pneumatic timers.
(2)
7 - 14 lb-in
(.8 - 1.6 N-m)
18 - 25 lb-in
(2.0 - 2.82 N-m)
#10 AWG
#10 AWG
8 -12 lb-in
(.9 -1.4 N-m)
B-vertical.ai
1234 56 78
A
B
C
D
E
F
G
H
CONFIDENTIAL AND PROPRIETARY INFORMATION. THIS DOCUMENT
CONTAINS CONFIDENTIAL AND PROPRIETARY INFORMATION OF
ROCKWELL AUTOMATION, INC. AND MAY NOT BE USED, COPIED OR
DISCLOSED TO OTHERS, EXCEPT WITH THE AUTHORIZED WRITTEN
PERMISSION OF ROCKWELL AUTOMATION, INC.
BULLETIN 700P INSTALLATION
INSTRUCTION SHEET
10000005242
Sheet
Size Ver
Of
42
B00
Dr. Date
- - - - - - - - - - - -