Owner manual

INSTALLATION INSTRUCTIONS
PHOTOSWITCH
R
SOLID STATE PLUG IN LOGIC OUTPUTS
IMPORTANT: SAVE THESE INSTRUCTIONS FOR FUTURE USE. REPLACEMENT PARTS F OR BASES MANUFACTURED AND SOLD BEFORE 1991.
BULLETIN NUMBER TYPE VOLTAGE SUPPLY CURRENT RATING RESPONSE TIME
63--64
or
63--66
DC Voltage
Output Adapter
24 VDC 30 mA
Depends upon
Control Used
12 VDC 15 mA
63--65
or
63--67
Open Collector
Logic Output
24 VDC 250 mA
15 VDC 150 mA
12 VDC 125 mA
63- 64 or 63- 66
SPECIFICATIONS
No Load 20 VDC.......................................
Load Resistance Not less than 550 Ohms....................
Ambient Temperature Range -- 2 0 °F to 135°F(--28°Cto57°C)..
Relative Humidity 95%..................................
Note: 63 --66 and 63--67 Outputs supersede the 63-- 64 and 63-- 65 Out-
puts respectively. The new plug-in Outputs are electrically and
physically interchangeable with the old, but with the following
minor exceptions.
1. The plastic cover on the 63 --66 and 63 --67 have curved domes
to match the curved spring retainers supplied on all Control
Bases with date code 8000 and higher.
2. For Series 60--1400 and 60--1600 Control Bases manufactured
and installed prior to January 1980, which included the flat-top
spring retainer, order the 63--66 plus a 63--71 flat-- top Adapter
for compatible Control Base mounting.
63- 65 or 63- 67
SPECIFICATIONS
Open Collector Rating as Current Sink 250mA for Vce = .25..
Ambient Temperature Range -- 2 0 °F to 135°F(--28°Cto57°C)..
Relative Humidity 95%..................................
Reverse Voltage Protection Shunt Diode....................
3. When these Logic Adapters are used with Model 4003 Versions
of Type 42RL Controls, only DC input power should be ap-
plied. The user must also be certain to add a jumper between
control terminals L2 and 2C. This ties the negative power sup-
ply line terminal to the negative of the output circuit. In placing
this jumper and in connecting the power supply leads, the cor-
rect polarity must be observed to avoid internal damage.