User manual

22
Bulletin 6185-C and 6185-B Industrial Flat Panel Monitors
Publication 6185-5.1
Note:
These monitors use a flat panel display, but they use the
workstation’s analog VGA interface. Because of this, some
setup screens may indicate that the monitor is operating as a
CRT (analog) device, rather than a flat panel (digital)
device.
If your video card does not support Plug and Play, or if you are using
Windows NT, you should the monitor type manually. These settings are:
• Plug and Play Monitor - 6185-C and 6185-B with Plug and Play
enabled system
• Super VGA 1024x768 - 6185-C manual setting
• Super VGA 800x600 - 6185-B manual setting
Depending on if you are using Windows NT, Windows 95 or Windows
98, accessing the settings differ.
Use the following table as a procedure guideline for accessing the
monitor types manually.
Table C
Procedures for Accessing Monitor Type Manually
Windows NT Windows 95 Windows 98
1. Open Control Panel 1. Open Control Panel 1. Open Control Panel
2. Open Display icon 2. Open Display icon 2. Open Display icon
3. Click Settings tab 3. Click Settings tab 3. Click Settings tab
4. Verify Desktop Area
(Resolution)
4. Click Advance
Properties button
4. Click Advance
Properties button
5. Verify Refresh
Frequency
5. Click Monitor tab 5. Click Monitor tab
6. Click Change button 6. Click Show all
Devices button
7. Click Show all
Devices button
7. Verify Manufacturer:
Standard monitor
types
8. Verify Manufacturer:
Standard monitor
types
9. Verify Models:
•
Plug and Play
Monitor
•
Super VGA 800x600
•
Super VGA
1024x768
8. Verify Models:
•
Plug and Play
Monitor
•
Super VGA 800x600
•
Super VGA
1024x768