User manual

Making Connections

Publication 6185-5.1

ATTENTION: Chassis ground must be connected for

safe operation of the monitor. The DC screw terminals on

the monitor have a chassis ground pin. However, some

DC sources may not provide a proper ground path. If you

fail to ground the monitor properly, the setup may result

in personal injury from electrical shock or damage to the

equipment.

ATTENTION: EXPLOSION HAZARD! – Do not

disconnect equipment unless power has been switched off

or the area is known to be non-hazardous.

Route the power wires from your 18-32 VDC power supply and

connect the leads to the DC input terminal block on the monitor as

shown in the following figure. Tighten the screw terminals to ensure

a good connection.

Note:

Be sure to follow the labeling on the DC power supply

terminal block to prevent damage to your monitor.

Figure 5 Connecting Power to the Terminal Block

Restore DC power.