User manual

Industrial 18.1" Flat Panel Monitor 57

Publication 6185-UM001B-EN-P

Appendix B: Video Cables

Appendix B: Video CablesAppendix B: Video Cables

Appendix B: Video Cables

You can use an HD-15 connector (all models) or a BNC adapter cable

(6185-V only) to connect the RAC6185 18.1" Flat Panel Monitor to the

host computer.

The HD-15 video cable you use with this monitor is equipped with a

conventional HD-15 connector at each end.

Note:

The following figure is the view looking into the pin end of

the male connector or solder term end of the female

connector.

Figure 33

HD-15 Video Connector

The following table provides the pin numbers and corresponding pin

assignments for the HD-15 video connector with the DDC2B capability:

Table I

Standard HD-15 Video Cable

Monitor (Female) Signal Description Host (Male)

1 Red Video 1

2 Green Video 2

3 Blue Video 3

4 Not Used 4

5 Return 5

6 Red Video Ground 6

7 Green Video Ground 7

8 Blue Video Ground 8

Not Used (6185-D and 6185-N)

DDC +5V (6185-V)

10 Sync Ground 10

11 Not Used 11

12 Bi-Directional Data 12

13 Horizontal Sync 13

14 Vertical Sync (VCLK) 14

15 Data Clock (SCL) 15

HD-15 Connector