User guide

9–10 Replacing the Backlight Tubes
Publication 6181-UM001D-EN-P
3. Reattach the display cable to the flat panel display by gently
plugging the connector into the small printed circuit board and
replacing the 2 screws that hold it in place.
ATTENTION: Do not overtighten the screws holding
the display cable to the printed circuit board. Tighten to a
torque of 1-2 in-lbs. (0.1-0.2 N-m)
4. Reattach the display assembly to the unit using the 6 screws.
5. Replace the retaining screw below the top hinge.