User guide

Rockwell Automation Publication 6155R-UM002E-EN-P - February 2014 35

Component Replacement Chapter 4

Replace a Drive

Follow these steps to replace a drive (HDD or SSD).

1. Read and follow the Drive Precautions

on page 34.

2. Follow the steps for Pre-configuration

on page 30.

3. Loosen the one captive thumbscrew that secures the drive assembly (A).

4. Pull the handle to slide the drive assembly out of the enclosure (B).

5. Remove the fours screws that secure the protective plate (C).

6. Remove the protective plate from the drive carrier (D).

7. Remove the four screws that secure the existing drive (HDD or SSD) to its

carrier (E).

8. Lift the cable connector end of the drive and disconnect the power and

data cables (F).

9. Remove the existing drive from its carrier (G).