User Manual

Bulletin 6153 and 6154 Industrial Computers with Integrated CRT18

Publication 6153-2.0

Figure 10 Rear Panel Controls – 8/12-Slot Units

VGA

AUX 2

–+–+

Factory Adjustments

Raster Rotation

Brightness

Contrast

Vertical Size

Degauss

Vertical Position

Horizontal Size

Horizontal Position

Note: The internal degauss will not prevent color impurities caused

by local magnetic fields. Make certain the Industrial Computer’s

enclosure is free of residual magnetism.

Tip: For best results, perform a manual degauss only after allowing

at least 15 minutes to pass following power-up or a previous manual

degauss.

ATTENTION: Do not attempt to change any of the

factory adjustments located on the rear of the Industrial

Computer chassis. These adjustments are for factory

trained personnel using special test and alignment

equipment and should not be required to obtain a good

display in the field.

