Instruction Manual

Specifying Message Packet Commands
with Send_StdDrv()
Appendix B
B-6
The supported command set includes commands that can generally be
executed by any SLC processor. Use these commands with the
Send_StdDrv() function call.
Command CMD (Hex) FNC (Hex)
SLC-500
Protected Typed Logical Read with 3 address
fields
0F A2
Protected Typed Logical W rite with 3 address
fields
0F AA
Basic
Diagnostic Counters reset 06 07
Diagnostic Loop 06 00
Diagnostic Read 06 01
Unprotected Read 01 N/A
Unprotected W rite 08 N/A
Diagnostic Status 06 03
Important: In the example formats that follow, CMD and FNC values are
expressed in hexadecimal notation; all other values are in decimal form.
The message packet fields for each of the commands are described in
more detail in the following pages. See page B-2 for more information
on formatting message packets.
Supported Command Set