User guide

I
Table of Contents
1.0 Introduction 1Ć1...............................................
1.1 Related Publications 1Ć4.....................................
1.2 Related Hardware and Software 1Ć5...........................
1.3 Terms and Conventions Used in This Manual 1Ć5................
2.0 Mechanical/Electrical Description 2Ć1...........................
2.1 Mechanical Description 2Ć1...................................
2.1.1 Remote I/O Module (M/N 57C416) 2Ć1...................
2.1.2 Shark Interface Module (M/N 57C554) 2Ć3................
2.1.3 Remote I/O Head (M/N 57C328) 2Ć4.....................
2.1.4 Remote I/O Head (M/N 57C330) 2Ć5.....................
2.1.5 Remote Drive Interface Head (M/N 57C329) 2Ć7...........
2.2 Electrical Description 2Ć8.....................................
2.2.1 Remote I/O Module (M/N 57C416) 2Ć8...................
2.2.2 Shark Interface Module (M/N 57C554) 2Ć9................
2.2.3 Remote I/O Head (M/N 57C328) 2Ć9.....................
2.2.4 Remote I/O Head (M/N 57C330) 2Ć10.....................
2.2.5 Remote Drive Interface Head (M/N 57C329) 2Ć10...........
2.3 Drop Numbers 2Ć11..........................................
2.4 Remote I/O Drop Hardware 2Ć12...............................
3.0 Installation 3Ć1................................................
3.1 AutoMax Remote I/O Coaxial Cable System Components 3Ć2.....
3.1.1 Drop Cable and Communications Passive Tap 3Ć4.........
3.1.2 Coaxial Cable 3Ć4.....................................
3.1.3 BNC Plug Connector 3Ć5...............................
3.1.4 BNC Tee Adapter 3Ć5..................................
3.1.5 75 Ohm Terminating Load 3Ć6...........................
3.1.6 BNC JackĆtoĆJack Adapter 3Ć6..........................
3.2 Installation Planning 3Ć7......................................
3.2.1 Installation Planning Procedure 3Ć7......................
3.3 Cable System Protection and Isolation Recommendations 3Ć8....
3.3.1 Coaxial Cable Protection 3Ć8............................
3.3.2 Electrical Isolation 3Ć8..................................
3.3.3 Chemical and Thermal Isolation 3Ć9......................
3.3.4 Physical Isolation 3Ć9..................................
3.4 Cable System Construction 3Ć9...............................
3.4.1 Cable Inspection and Testing 3Ć9........................
3.4.2 Cable Pulling 3Ć10......................................
3.4.3 Cable Termination 3Ć10..................................
3.4.4 Cable Segment Testing 3Ć13.............................
3.4.5 Constructing Long Cable Segments 3Ć14..................
3.5 Module Installation 3Ć15.......................................
3.5.1 Installing the Remote I/O Module (M/N 57C416) 3Ć15........
3.5.2 Installing the Shark Interface Module 3Ć17.................
3.5.3 Installing the Remote I/O Head (M/N 57C328 and
M/N 57C330) 3Ć18......................................