User guide

 Copyright Reliance Electric Industrial Company 1996.
IBMĆXT,ĆAT are trademarks of International Business Machines,Inc.
Multibus is a trademark of Intel Corporation.
Buss is a registered trademark of Bussman, Cooper Industries
AMP is a trademark of AMP, Inc.
Amphenol is a trademark of Amphenol, Inc.
Belden is a trademark of Belden, Inc.
Kermit is a trademark of the trustees of Columbia University.
ReSource, and Shark are trademarks of Reliance Electric Company
or its subsidiaries.
Reliance, AutoMax and AutoMate are registered trademarks of Reliance Electric
Company or its subsidiaries.
The information in this manual is subject to change without notice.
DANGER
ONLY QUALIFIED ELECTRICAL PERSONNEL FAMILIAR WITH THE
CONSTRUCTION AND OPERATION OF THIS EQUIPMENT AND THE HAZARDS
INVOLVED SHOULD INSTALL, ADJUST, OPERATE, OR SERVICE THIS
EQUIPMENT. READ AND UNDERSTAND THIS MANUAL AND OTHER
APPLICABLE MANUALS IN THEIR ENTIRETY BEFORE PROCEEDING. FAILURE
TO OBSERVE THIS PRECAUTION COULD RESULT IN SEVERE BODILY INJURY
OR LOSS OF LIFE.
DANGER
THE USER IS RESPONSIBLE FOR CONFORMING WITH ALL APPLICABLE
LOCAL, NATIONAL, AND INTERNATIONAL CODES. WIRING PRACTICES,
GROUNDING, DISCONNECTS, AND OVERCURRENT PROTECTION ARE OF
PARTICULAR IMPORTANCE. FAILURE TO OBSERVE THIS PRECAUTION
COULD RESULT IN SEVERE BODILY INJURY OR LOSS OF LIFE.
WARNING
THE USER MUST PROVIDE AN EXTERNAL, HARDWIRED EMERGENCY STOP
CIRCUIT OUTSIDE OF THE CONTROLLER CIRCUITRY. THIS CIRCUIT MUST
DISABLE THE SYSTEM IN CASE OF IMPROPER OPERATION. UNCONTROLLED
MACHINE OPERATION MAY RESULT IF THIS PROCEDURE IS NOT FOLLOWED.
FAILURE TO OBSERVE THIS PRECAUTION COULD RESULT IN BODILY INJURY.
WARNING
INSERTING OR REMOVING A MODULE MAY RESULT IN UNEXPECTED MACHINE
MOTION. POWER TO THE MACHINE SHOULD BE TURNED OFF BEFORE
INSERTING OR REMOVING THE MODULE. FAILURE TO OBSERVE THESE
PRECAUTIONS COULD RESULT IN BODILY INJURY.
CAUTION: This module contains staticĆsensitive components. Do not touch the
connectors on the back of the module. When not in use, the module should be stored in
an antiĆstatic bag. The plastic cover should not be removed. Failure to observe this
precaution could result in damage to, or destruction of, the equipment.