Manual

Installing P o le Conversion Kits 500LC–2PCK, 4PCK, 6PCK, LS3 to Bulletin 500LC Lighting Contactors

Publication 500LC–IN004A–EN–P May 2005

Remove the plas t ic o p erat ing screw !

7. Remove the plastic operating screw from the lighting contactor.

8. Reinstall the lighting contactor into the enclosure and tighten the mounting

screws.

9. Reconnect all wires previously removed. Tighten control connections to

10 in–lb. Tighten t he line and load connections to 18 in–lb.

10. Close circuit breakers and check electrical operation of the lighting contactor

with the new control voltage.

manual

operating

screw

Figure 3 Manual operating screw

Do not manually operate

until all power and control

circuits are disconnected.

push — pull

381339–266