INSTALLATION MANUAL Manual

Chapter 6
Installing the Vision Components
6-7
If you have to make this connection, use the steps below to attach the cable
to the module using Belden 9463 cable.
1. Remove the male connector for the port labeled RIO
and wire it as shown below:
Shield
Blue2
Clear 1
2. Plug the wired connector into the processor's
female connector labeled RIO.
3. Route the cable to the adapter as shown in the
wiring documentation.
4. Attach the other end of the cable to the adapter.
16781
After completing the installation of your vision components,
If you are: Go to chapter:
Installing I/O 7
Not installing I/O 8
Connect to Remote I/O Link
What to do Next