INSTALLATION MANUAL Manual
Chapter 6
Installing the Vision Components
6-5
Light Pen
To connect the light pen, connect the light pen’s cable to the user
interface’s port labeled LIGHT PEN as shown below.
BLUE
GREEN
RED
POWER
LIGHT
PEN
SYNC
INPUT
16902
Light pen
User interface
To connect the camera to the CVIM module, follow the steps below.
Follow this procedure for each camera you connect to the CVIM module.
1. Connect the cable to the module.
If connecting
camera:
Use one of these cable:
2801YB
2801YC
2801YD
2801NC5, NC6, NC7
2801NC13, NC14, NC15, NC16
2801NC15, NC16, NC17
2. Route the cable from the VISION
PROCESSOR to the camera as
described in the wiring information.
Back of
camera A
3. Connect the cable to
the camera.
16779
Camera
CVIM module
Connect the Camera to the
CVIM Module