INSTALLATION MANUAL Manual
Chapter
5
5-1
Installing the Peripherals
This chapter describes how to install the following peripherals:
programming terminal
209, 418, or 480 Mbyte industrial disk (5710-ID4, -ID5, -ID6, -ID7)
159Mbyte industrial disk (5730-ID3)
4-port distribution panel (5710-DPI)
program loader (5710-PL/B)
The table below lists the page numbers for installation procedures.
To complete installation of: See page:
programming terminal 51
industrial disk 52
4port distribution panel 59
program loader 59
If you are installing an industrial disk and/or a distribution panel, make
sure you have mounted and grounded these components as shown in
chapters 2 and 3.
Important: Save the packing material in case you have to ship a disk.
If you are connecting a programming terminal to the RM, follow
these steps.
1. Install a DH+ Interface Board (cat. nos. 1784-KT,-KTK1) in the
programming terminal.
2. Use the appropriate interconnect cable to connect the interface board
to the terminal as shown below. For more information on
interconnect cables, see appendix C.
Chapter Objectives
Where to Begin
Install a Programming
Terminal