INSTALLATION MANUAL Manual

Chapter 4
Installing the Modules
4-26
ATTENTION: Do not use a transceiver that has a disabled
SQE test to connect an EI module to an Ethernet network
because it could disrupt network activity.
Check Jumper Settings
The jumpers on the EI module are factory set. Make sure the jumpers are
set as shown below.
18544
123
JP3
123
JP2
123
JP1
123
JP0
(Front)
Top of EI module
To install the OSI interface module, use the worksheets as guides and
complete the following:
set the switches
install the module in the chassis
install the battery
set the pushwheel
make connections to the module
Set the OSI Interface Switches
Set the OSI interface module’s switches for:
operating modes (switch 1)
communication defaults (switch 2)
ATTENTION: If you perform operations on a module
improperly, you may cause an electrostatic discharge, which can
damage the module. Perform internal operations, such as setting
the jumpers, only in static-safe environment.
OSI Carrierband/Broadband
Interface Module