INSTALLATION MANUAL Manual

Chapter 4
Installing the Modules
4-17
Install the Battery
To install the RS battery, see “Install the Battery” section on page 4-11
for instruction.
Set the RS Module Address
Follow the steps below to set the RS module address. For RS2, the address
must start at 1 for the first RS and be consecutive for the other RS modules
up to 4.
For RS5, the address can be spread among the RS modules, or all four
addresses may be used on one RS5. The addresses must be consecutive.
RS5
1. Locate the pushwheel on the front panel of the RS.
2. Set the pushwheel as indicated on the worksheet.
Setting the pushwheel:
To: Push the:
decrease the number
increase the number
top button
bottom button
19788
14
Connect
I/O
To connect remote I/O to the ports labeled CH 1 to CH 4, and local I/O to
CH5, see chapter 7.
The RS5 pushwheels: Is equivalent to:
14 four RS2 modules' pushwheels.
11 one RS2 module's pushwheel.