INSTALLATION MANUAL Manual
Chapter 4
Installing the Modules
4-12
Set the KA Module Address
Follow the steps on the next page to set the KA module address. The
address must start at 1 for the first interface module and be consecutive for
the other interface modules up to 4.
1
1. Locate the pushwheel on the front panel of the
KA module.
2. Set the pushwheel as indicated on the worksheet.
Setting the pushwheel:
To: Push the:
decrease the number
increase the number
top button
bottom button
KA module
17973
Connect the RM/KA Module
The table below lists what you can connect to the RM/KA module:
You can connect the module to: Using channel:
RM KA module
programming terminal 2A 2A
RS232, RS422, RS423 devices (terminal or modem) 1 1
DH link 2B or 3 2B or 3
DH+ link 2B or 3 3B or 3
Check the appropriate worksheet for the RM/KA module to see which
connections to make. To connect a programming terminal, see chapter 5.
To connect an RS-232, RS-422 or RS-423 device to channel 1, follow
these steps.
1. Depending upon the type of device you are connecting, use the pin
assignments in Table 4.B through Table 4.D to construct a cable.