INSTALLATION MANUAL Manual

Chapter 4
Installing the Modules
4-4
Leaking Battery
If the hermetic seal of the case is broken, ventilate the area. Using tongs,
scoop, or shovel, remove the leaking battery to a well-ventilated
fire-protected area.
Fire
ATTENTION: Do not use water or carbon dioxide (CO2) fire
extinguishers on the fire. Lithium is reactive with
these substances.
As described for overheated batteries, explosion or violent rupture is
possible. If a cell is ruptured, the exposed lithium is combustible and is
reactive in water. If lithium is burning, use a Class D Powder fire
extinguisher or smother with a graphite powder, such as Lith-X, or an
appropriate metal fire extinguishing powder, applied with a long-handled
tool. Avoid exposure to toxic fumes from burning lithium.
Gather the module documentation and check to see which modules you are
installing. See Table 4.A for which page you should go to for
the procedures.
Table 4.A
Installing
PI Modules
If you are installing this module: See page:
power supply (5120P1/B) 45
RM (5130RM1,RM2)
KA module (5130KA)
48
RS (5150RS2, RS5) 415
LP (5250LP1,LP2,LP3,LP4) 418
vision processor (5370CVIM, CVIM2, CVIMC) 420
MicroVAX Information Processor module
(5730CPU1, 5731CPU1, CPU2)
421
EI module (5820EI) 424
OSI carrierband interface module (5820CC) 426
OSI broadband interface module (5820CBx) 426
Gather the Module
Documentation