INSTALLATION MANUAL Manual
Chapter 2
Mounting the Components
2-11
Check the mounting documentation to see how you should mount the black
and white monitor.
If mounting: Make sure:
on a table or shelf
• the connectors are accessible so you can connect the cables to the
monitor
• the table or shelf can hold the weight of the monitor
place the monitor in the position indicated by the mounting documentation.
on a shelf that
slides out of a rack
• to attach the slides and shelf to the rack by following the
documentation for the slides
• to place the monitor on the slides
a color monitor you follow the rack mounting procedure at the beginning of this chapter.
To mount the I/O board, attach the:
I/O interface box to I/O board and attach to mounting surface
user interface box to I/O board and attach to mounting surface
Attach I/O Interface Box
Attach the I/O interface box to the I/O board by following the steps below.
1. Locate the 50-pin connector on the side of the I/O board.
0123456780
49
13
11
1
KEY
SLOT
16903
2. Plug the I/O interface box’s 50-pin connector to the I/O board’s
50-pin connector.
0123456780
49
13
11
1
KEY
SLOT
C
V
I
M
R
S
/
2
3
2
16904
3. Secure the I/O interface box and the I/O board to the mounting
surface using two screws.
Mounting a Black and White
Monitor (2801N6,N9,N20)
Mounting the I/O Board
1771JMB