INSTALLATION MANUAL Manual

Summary of Changes

In general, we improved the format and added greater detail to this manual.

The table below lists specific changes we made:

We have: To chapter/appendix:

added and updated drawings for the chassis, I/O scanner (RS5),

power supply module, Color CVIM module, CVIM2 module, User

Interface box (2801N26), I/O interface box (2801N27) and

camera (2801YE)

updated the Rack Mount the Components" and Mount the Fan

Assembly" procedures

updated the drawing for grounding the components 3

updated the installation procedures for:

• power supply

• RS (added steps for RS5)

• Replace a MicroVAX Information Processor"

We have also combined the installation procedures for RM and KA

module into one procedure

replaced information on industrial disk 5710ID4 and ID5 with

5710ID6 and ID7

added the information on configuring the extendedlocal I/O

adapter module

updated these procedures:

• Connecting Remote I/O to the RS"

• Connecting the Extendedlocal I/O link"

• Connecting to a PanelView Operator Terminal"

updated the power supply information 10

updated the procedure on Checking the PI modules" and added

new information for RS5

combined the chapters on MicroVAX Information Processor and

MicroVAX Information Processor EE or EP into one chapter and

added the Verify and Format Disk for 5730CPU1)" section

updated the installing and removing PI modules sections A

added dimensions information for the new user interface box

(2801N26), I/O interface box (2801N27) and camera (2801YE)

added flowcharts for RS5 D

To help you find new or updated information in this release of the manual, we

have included change bars as shown to the left of this paragraph.

Additional Information