INSTALLATION MANUAL Manual

Index
I–6
illustration, 14
installation, 48
keyswitch, 415
ports 2A and 2B, C3
setting switches and jumpers, 48
RS, 91
150-Ohm termination resistor, 92
battery holder, 417
connecting I/O link cable, 92
disposal of battery, 41
grounding, 92
illustration, 14
installing, 415
module address, 417
start up and configure, D1
termination resistors, 415
RS-232, 48, 412
pin assignments, 413
OSI interface module, 429
RS-422, 412
pin assignments, 413
RS-423, 412
pin assignments, 414
RS2
changing a memory module, A1
check LEDs, 114
RS5, check LEDs, 115
run
MicroVAX Information Processor,
self-test, 126, 127
power-up diagnostic self-test, 123
self-test on individual devices, 126
S
scanner. See RS, 14
self-test error codes, table of, 128
serial port
25-pin, C4
9-pin, C3
set
default boot device, 1217
default recovery, 1218
hardware defaults, 1217
pushwheel address, OSI interface
module, 428
switches, OSI interface module, 426
set up, console terminal, MicroVAX
Information Processor, 122
software
MAP Station Manager, 428, 433
MicroVAX Information Processor, start up
and configure, D6
OSI interface module, start up and
configure, D8
specifications, power supply, 45
start up and test MicroVAX Information
Processor, 121
configure defaults, 121
perform power-up diagnostics, 121
run system exerciser, 121
set up terminal, 121
verify industrial disk, 121
static-safe environment, 12, 41
storing, lithium battery, 43
switch assemblies, SW1, extendedlocal
I/O, 77
switch settings, C2
extended-local I/O adapter module, 77
switches
conventions, 81
direct communication module switches,
82
PLC interface module, 83
RediPANEL, 86
RediPANEL Keypad module, 86
settings, 1770-KF2, 1785-KE, C2
system exerciser display codes, table of,
1212
T
table
hardware self-test error codes, 128
system exerciser display codes, 1212
test device numbers, 126
test numbers, device mnemonics, 126
terminating link, extendedlocal I/O, 96
termination resistors, 98
150-Ohm, 92
extendedlocal I/O, 96
transformers, 101
transmission rate, C3
trunkline/dropline configuration, 91
U
user interface box
connection
black and white monitor, 64
color monitor, 64