User Manual

Publication GMSI00-UM001A-EN-E - February 2005
16 The Enpac Ex
Remove the battery pack from the Enpac Ex
1. Remove the two 1/4 turn fasteners on the battery access panel located
on the underside of the data collector (see illustration below).
2. Release the locking tab on the right side of the cell and lift the battery
pack out of the Enpac Ex.
Refit the battery pack into the Enpac Ex
1. Insert the battery pack in the Enpac Ex and ensure the catch on the
locking tab is located and latched.
2. Place the battery access panel on the Enpac Ex and tighten the 1/4 turn
fasteners. You may need to press firmly down on the battery access
panel to tighten the fasteners.
Release fasteners to
access battery pack
Release locking tab
to remove battery