Safety Relay User Manual Owner's manual

110 Rockwell Automation Publication 440C-UM001C-EN-P - November 2014
Chapter 16 Security and Password
Compatibility
The Safety Relay Password feature is supported on:
• Connected Components Workbench version7 and later
• Guardmaster 440C safety relays with revision 7 or later firmware
Users with earlier versions of the software and/or hardware are advised to
upgrade the software and firmware. See Upgrade the Firmware
on page 141 for
instruction on firmware upgrades.
Work with a Locked Safety
Relay
The following workflows are supported on compatible Guardmaster 440C safety
relays (firmware revision 7 or later) and CCW version 7 or later.
Upload from a Password-Protected Safety Relay
1. Launch the CCW software project with your Guardmaster 440C safety
relay configuration.
2. Double-click the Guardmaster 440C safety relay in the Project
Organizer to open the Safety Relay workspace.
3. Select Upload from the pull-down menu in the safety relay header.
4. Select the target safety relay in the Connection Browser.
5. When requested, provide the safety relay password.
Connect to a Password-Protected Safety Relay
1. Launch the CCW software project with your Guardmaster 440C safety
relay configuration.
2. Double-click the Guardmaster 440C safety relay in the Project
Organizer to open the Safety Relay workspace.
3. Select Connect from the pull-down menu in the safety relay header.
4. Select the target safety relay in the Connection Browser.
5. When requested, provide the safety relay password.
Download to a Password-Protected Safety Relay
1. Launch the CCW software project with your Guardmaster 440C safety
relay configuration.
2. Double-click the Guardmaster 440C safety relay in the Project
Organizer to open the Safety Relay workspace.
3. Select Download from the pull-down menu in the safety relay header.
4. Select the target safety relay in the Connection Browser.
5. When requested, provide the safety relay password.