Manual

ManualsBrandsRockwell Automation ManualsEquipment42EF RightSight DeviceNet Photoelectric Sensors

Installation Instructions

RightSightt DeviceNett PHOTOSWITCH

Photoelectric Sensors

Sensing Mode

Polarized

Retroreflective

Diffuse

Sharp

Cutoff Diffuse

Background Suppression

Glass

Fiber Optic

Transmitted Beam

Version 50mm (2in) 100mm (4in) 20m Receiver 4m Receiver Source

Cat No.

5-pin micro QD 42EF- P2LDB- F5 42EF- D1LDAK- F5 42EF- SIMDA- F5 42EF- B1LDBC- F5 42EF- B1LDBE - F5 42EF- G1LDA- F5 42EF- R9LDB- F5 42EF - R9LDBV- F5 42EF- E1EDZB- F5

2m cable Consult f actory 42EF- E1EZB- A2

Optical

1 Sensing Distance 3m (9.8ft) 500mm (20in) <127mm (5in) 50mm (2in) 100mm (4in)

Varies with fiber op-

tic cable

20m (60ft) 4m (13ft) 20m (60ft)

2 Field of View

1.5_ 5_ 7_ 20_ 8_ 7_

Not applicable

3 Transmitting LED Visible Red 660nm Infrared 880nm Not applicable Infrared 880nm

4 Sensitivity Adjustment No Yes No Yes No

Electrical

5 Supply Voltage 11--25V DC

6 Current Consumption 65mA maximim

7 Power Consumption 1.6W maximum

8 Response Time 3ms 3ms 3ms 3ms 3ms 3ms 11ms 11ms Not applicable

9 Protection Output: short circuit protected, Power: Reverse polarity, False Pulse (300ms power ON delay)

Power: Reverse

polarity

Mechanical

10 Housing Material Mindel

11 Lens Material Acrylic

12 Indicators SeeTable1. Green: Power

Environmental

13 Operating Temperature

-- 2 5 _ to +70_C(--13_ to +158_F)

14 Operating Environment NEMA 4X, 6P, IP67; 8270kPa (1200psi) washdown

15 Vibration 10--55Hz, 1mm amplitude, meets or exceeds IEC 947--5--2

16 Shock 30G, meets or exceeds IEC 947--5--2

17 Relative Humidity 95%

18 Approvals UL, CSA, CE for all applicable directives, DeviceNet conformance tested

DeviceNet

19 Network Interface DeviceNet

20 Protocol Selectable Change-of-State (COS) or Strobing

21 Operating Mode Selectable Light/Dark operate

22 Autobaud Detect Selectable ON/OFF

23 Communication Rate Selectable 125kb, 250kb, 500kb

24 Supported Node Address Selectable 0 to 63 (63 factory default)

25 Timer ON Delay and OFF Delay/One Shot (0 to 65,535ms, 1 or 10ms time base)

26 Counter Adjustable with output bit (0 to 65,535 counts)

27 Motion Detect Adjustable with output bit (0 to 65,535ms, 1ms time base)

28 Margin Diagnostic Selectable with dual thresholds (0.7 to 1.5 and 0.7 to 2.0)

29 Margin Diagnostic Type Selectable static or dynamic

Summary of content (4 pages)

PAGE 1
Installation Instructions RightSightt DeviceNett PHOTOSWITCHR Photoelectric Sensors Sensing Mode Polarized Retroreflective Sharp Cutoff Diffuse Diffuse Version DeviceNet Environmental Mechanical Electrical Optical Cat No.
PAGE 2
Typical Response Curves 2 1 0.01 0.1 1 10 (0.03) (0.328) (3.28) (32.8) Distance to 76mm Reflector, 92- 39—m (ft) Polarized Retroreflective Beam Pattern - 10 0 1 2 (3) (7) Distance—m (ft) 3 (10) 0 --5 0 20 40 (8) (16) Distance—cm (in) 60 (234) 0.1 0 --0.1 - 0.2 0 1m (3) 2m (7) 3m (10) 10 (0.40) 26.5 (1.04) 100 (328) 69 (2.72) 4 (0.16) 2m (6.56ft) Cable 49.7 (1.96) 3.6 (0.145) Diameter Clearance for #6--32 Screw (2 Places) 2 100mm 10 1 50mm 0 0.5 0.4 0.25 0.12 0 --0.12 --0.25 - 0.
PAGE 3
Accessories Straight Bracket #60--2656 Right Angle Bracket #60--2657 30_ 3 Places 15.7 (0.62) 90_ 018.5 (0.728) 70 (2.78) R 24 (0.95) 52 (2.04) 2 Plc 15 (0.059) Ref 35.8 (1.41) 15.7 (0.62) 29 (1.143) 4.6 (0.181) 4 Plc 42.4 (1.67) 28.6 (1.125) 29 (1.143) 4.6 (0.181) 4 Plc 12.7 15.7 (0.50) (0.62) R 15 (0.59) 12.7 (0.50) Note: 18mm nut must be installed prior to installing aperture if threads on optics snout are to be used. 7.95 (0.31) 42.4 (1.
PAGE 4
Configuration RightSight DeviceNet photoelectric sensors interface directly to the network without the need for a DeviceLink adaptor. After securing the sensor to a stable surface or support, it will be necessary to configure some of the parameters shown on Table 2 using a suitable network configuration tool such as the Rockwell DeviceNet Manager. For remote configuration the DeviceView Hand-Held Configurator (2707--DNC) is available. Table 1.