Safety Version - User Manual User guide

Troubleshooting 11-17
Control Module Replacement
(Bulletin 284)
Removal of Control Module
1) Disconnect from power source
2) Remove motor cable.
3) Loosen the four mounting screws.
4) Unplug the Control module from the base by pulling forward.
Installation of Control Module
5) Install control module.
6) Tighten four mounting screws.
7) Install all cables to starter module.
Figure 11.2 Bulletin 284 Control Module Replacement
ATTENTION
!
To avoid shock hazard, disconnect main power
before working on the controller, motor, or control
devices
2
1
Motor Cable
4
3
3
1
2
30 lb-in/
3.39 Nm
Note: DeviceNet base module is
shown