User Manual

Bulletin 283 CIP Information C-25
Control Supervisor Object -CLASS
CODE 0x0029
No class attributes will be supported.
A single instance (instance 1) of the Control Supervisor Object will
be supported.
Attribute ID
Access
Rule
Name Data Type Value
3 Get/Set Run 1 BOOL
Run1 output also map to DOP
instance 1.
7 Get Running 1 BOOL
9 Get Ready BOOL
10 Get Tripped BOOL
12 Get/Set Fault Reset BOOL 0->1 = Trip Reset
100 Get/Set Keypad Mode BOOL 0=Maintained; 1=Momentary
101 Get/Set Keypad Disable BOOL 0=Not Disabled; 1=Disabled
115 Get Warning Status WORD
Bits 0-1 = reserved
Bit 2 = PL Warning (283 Only)
Bit 3 = reserved
Bit 4 = PR Warning (283 only)
Bit 5 = CP Warning
Bit 6 = IO Warning
Bit 7 = reserved
Bit 8 = PI Warning (283 only)
Bit 9 = DN Warning
Bits 10-12 = reserved
Bit 13 = HW Warning
Bits 14-15 = reserved
124 Get/Set Trip Enable WORD Bit enumerated trip enable word
130 Get/Set Trip Reset Mode BOOL
0=manual
1=auto
131 Get/Set Trip Reset Level USINT 0 – 100%; default = 75
151 Get Base Enclosure WORD
Bit 0 = IP67
Bit 1 = NEMA 4x
Bits 2-15 reserved
152 Get Base Options WORD
Bit 0 = Output Fuse
Bit 1 = Safety Monitor
Bit 2 = CP Fuse Detect
Bits 3-7 = Reserved
Bit 8 = 10A Base
Bit 9 = 25A Base
Bit 10-15 = Reserved
153 Get Wiring Options WORD
Bit 0 = Conduit
Bit 1 = Round Media
Bits 2-15 = Reserved
154 Get Starter Enclosure WORD
Bit 0 = IP67
Bit 1 = NEMA 4x
Bits 2-15 reserved
155 Get Starter Options WORD
Bit 0 = Full Keypad
Bit 1 = Safety Monitor
Bit 2 = Source Brake
Bit 3-15 = Reserved
156 Get Last PR Trip UINT See Parameter 61 for definitions