User Manual
C-16 Bulletin 283 CIP Information
Discrete Input Point Object —
CLASS CODE 0x0008
➊
The following class attributes are supported for the Discrete Input
Point Object:
Table C.35 Discrete Input Point Object Class Attributes
Four instances of the Discrete Input Point Object are supported. All
instances contain the following attributes:
Table C.36 Discrete Input Point Object Instance Attributes
The following common services are implemented for the Discrete
Input Point Object:
Table C.37 Discrete Input Point Object Instance Common Services
➊ This assembly does not exist on the Bulletin 283A.
Discrete Output Point Object —
CLASS CODE 0x0009
The following class attributes are supported for the Discrete Output
Point Object:
Table C.38 Discrete Output Point Object Class Attributes
Attribute ID Access Rule Name Data Type Value
1 Get Revision UINT 2
2 Get Max Instance UINT 4
Attribute ID Access Rule Name Data Type Value
3 Get Value BOOL 0=OFF, 1=ON
115 Get/Set Force Enable BOOL 0=Disable, 1=Enabl;e
116 Get/Set Force Value BOOL 0=OFF, 1=ON
Service
Code
Implemented for:
Service Name
Class Instance
0x0E Yes Yes Get_Attribute_Single
0x10 No Yes Set_Attribute_Single
Attribute ID Access Rule Name Data Type Value
1 Get Revision UINT 1
2 Get Max Instance UINT 4