User Manual
C-10 Bulletin 283 CIP Information
Table C.26 Instance 163 is the standard input (produced) assembly with
Network Outputs
➊ For Bulletin 283A only.
SMC Dialog Plus Native
Assemblies
These assembly instances have the same data format as the ScanPort
control and status registers on the SMC Dialog Plus soft starter. They
are intended for use by customers that are accustomed to using the
SMC Dialog Plus product on DeviceNet.
Table C.27 SMC Dialog Plus Native Consumed Assembly
Table C.28 SMC Dialog Plus Native Produced Assembly
Instance 163 — Standard Produced Starter with Network Outputs
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 — — — Ready —
Running
Fwd
— Tripped
1— —140M On
HOA
Stat.
User In 4 User In 3 User In 2 User In 1
Reserved
➊
Reserved
➊
Reserved
➊
Reserved
➊
2 Net Out 8 Net Out 7 Net Out 6 Net Out 5 Net Out 4 Net Out 3 Net Out 2 Net Out 1
3
Logic
Enable
Stat
Net Out
15
Net Out
14
Net Out
13
Net Out
12
Net Out
11
Net Out
10
Net Out 9
4ZIP CCV (low)
5 ZIP CCV (high)
Instance 172 — SMC Dialog Plus Native Consumed Assembly
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 Reserved Reserved
FLT
Reset
Reserved Start Stop
1Reserved
Instance 172 — SMC Dialog Plus Native Produced Assembly
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 Faulted Reserved Stopping Starting Reserved Running Enabled
1 In 4 Stat In 3 Stat In 2 Stat In 1 Stat Reserved At Speed